The Great Dollhouse Renovation!

My girls were the lucky recipients of a hand-me-down dollhouse from their Mardie and Pardie (is anyone else noticing that none of my children’s grandparents have normal names yet?) a couple of years ago. It’s wooden, beautifully handmade, and very solid.

But kind of old-fashioned.

And as you might have figured out if you’re familiar with my Instagram page, I don’t really do old-fashioned at home.

*cue music* It’s time for a makeover!

I had hinted to Benji for quite a while that the dollhouse could use with a bit of a face lift, but my whinging hinting fell on deaf ears. So there was only one thing left to do – get the job done girl.

With special thanks to Ryobi tools, this is how I made our little dolls house go from drab, to fab.

IMG_5027
“She’s wearing overalls, she must know how to use tools”

Now, I know what you’re thinking, “she’s wearing overalls, she must know how to use tools.”

WRONG!

My idea of DIY, is getting stuff out of the shed and then standing behind Benji, loudly offering my guidance on what I think he’s doing wrong as he goes about the task at hand. But this time I was determined to do it myself. I’m a woman, I can do anything!

IMG_5029
Benji: “Are you sure you want to do this?” Getouttamyway Benji.

Using the One+ 18V Compact Drill was easy, but kind of counter intuitive to start with for a thinking girl – “So I have to push the drill into the dollhouse to get the screws out? Huh?” Once my brain got over that little fact, and realised that this was going to make my life approximately 1052 times easier, I got into it and removed all those screws holding the house together quicker than I can make my way through a packet of Tim Tams.

The backing board was next to come off, and that was just a matter of using a little elbow grease and some pent-up frustration. A few strong taps (“like you mean it” according to Benji) and it was off.

IMG_5028
Eek, there’s no turning back now.

It was at about this point – five minutes in, that I got a little bored out in the shed and needed a little something to keep me going. Luckily, this is where the One+ 18V Bluetooth Radio comes in handy. It’s small, lightweight, has AM/FM, aux and Bluetooth capabilities and uses the same battery pack as my drill. Sorry neighbours, but this bad boy is getting turned up and I’m getting my shed-oke (totes a word) on.

Now, the wall of the dollhouse was probably the part of the house I disliked the most and was most keen to replace. To get rid of the old wallpaper, I set my 2000W Corded Heat Gun to low and warmed up the backing enough to scrape that bad boy off. Good riddance! Using my limited computer skills to good use, I made up some wall paper, printed it on card and using 84 2 rolls of double-sided tape, lived out my fantasy of having a house with beautiful wallpaper in every room, in miniature form.

IMG_5120
New versus old… Ugh, get rid of it now!

In hindsight, I should have used PVA to glue down the paper, as the taped paper buckled slightly. If I was a perfectionist, I would have redone it, but it isn’t noticeable to anyone but me, so I’ve left it as is!

Next came the part I was dreading the most, and more than likely was the reason I avoided doing the renovation myself for so long – the sanding. Ugh…

Thankfully though, thanks to the 100W Multipad Sander, the old varnish came off that bad boy fast and easy. I decided not to disassemble the entire dollhouse because I’m lazy like that, which meant there were lots of little nooks to get into. The sander handled these with ease and I was able to sand the timber back to its former glory without too much mess or fuss. Smooth as bruh.

IMG_5312
Super easy to use. Dare I say it made sanding fun? Too far?

Because I’m a narcissist at heart, I decided the colour scheme for the dollhouse would mimic that of our renovation that we’re about to undertake, so off I went to Bunnings and picked up some sample pots of the colours I’ve had my eye on – Dune for the exterior walls and Basalt for the Roof. Snow Peak for the interior walls which I watered down to whitewash the floorboards to show the beautiful wood grain.

IMG_5313
The whitewashed flooring and herringbone “marble tiling”. So chic. So what I wish I could have in my actual big house.

Finally, it was time to put the house back together and see if it actually looked any good…

Drum roll please…

IMG_5311
Time to see if it’s been worth the effort or if I’ve just ruined a perfectly fine dollhouse…

Success! Avery running out to see the finished product and looking at me with delight was a major highlight. “I love it!”

*heart swells with pride*

I made this for her. Me. Not Benji. Just me. I must admit, I didn’t realise how proud of myself I would be at the end of this project. It wasn’t particularly difficult, or challenging, but it was something that I would usually make Benji do for me. I feel a real sense of pride in my achievement and I must admit, I’ve developed a bit of a taste for DIY…

IMG_5310
Happy girl, happy Mum

Watch out shed, I’m coming to see what else I can play with next!

This has been a sponsored collaboration with Ryobi, but we do not endorse or work with any products or brands we do not use and love.   

Ryobi delivers affordable power tools with pro features, all backed by their 6 Year Warranty* and are available exclusively at Bunnings Australia and New Zealand.

* 6 year warranty applies to cordless products registered at http://www.ryobi.com.au. Batteries and chargers have 3 year warranty only. Corded tools have a 4 year warranty.

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s